Getting Started

Step 1 – Connect

  • Download the iSmartAlarm app from the App Store or Google Play.
  • Launch the app and sign up for an account.
  • Follow the app’s instructions to first install your CubeOne™ and Contact Sensors.
  • Once installation for the CubeOne™ and Contact Sensors is complete, follow the app’s instructions to add additional devices to install the Spot camera.

Step 2 – Placement

  • Place each of your devices in the appropriate locations (see examples below)

 

 

 

Adding Additional Sensors or Devices

  1. Make sure your smartphone and CubeOne are connected to the same Wi-Fi network.

  2. Remove clear plastic tab from the device and make sure the LED flashes once.

    Note: If the clear plastic tab has already been removed for more than 1 hour, but the device has not been added, reset the device by taking it out the battery for 15 seconds, then re-inserting it. Make sure the LED flashes once to ensure the battery is live.

  3. In the app, tap Devices > + > Sensor and Devices.

  4. Follow the remaining instructions in the app.

Adding Family Members

To add a member to your Home,

  1. Have the member download the iSmartAlarm app and create an account.
  2. When asked if they would like to Join or Create a home, select Join. The app will then ask them to scan a QR code.
  3. On the Superuser or Administrator’s phone, open the drawer, tap Members > then tap + in the top right corner
  4. Scan the QR code with the new members' phone.

If they're already a member of another Home,

  1. Open the drawer by swiping from the left edge of the screen
  2. Tap the down arrow button > Add New Home > select Join
  3. On the Superuser or Administrator’s phone, open the drawer, tap Members > then tap + in the top right corner
  4. Scan the QR code with the new members' phone.
  5. They've successfully also become member of your Home.